CHAPTER 1 - SYSTEM OPERATIONLSM 880 Left Tool Area and Hardware Control Tools ZEISS10/2014 V_01 000000-2071-464 4035.5.2.2 Select ObjectiveSelect the Objective tab from the Objective tool,which will show the Name of all objectives with anassigned nosepiece Position. If AutomaticComponent Recognition (ACR) is available thecorrect objective Name and Position will beupdated automatically. Otherwise you have toproceed manually as follows after screwing theobjective into then nosepiece:Click on the Objective icon button of therespective nosepiece position, which is indicatedon the nosepiece. This will open the Objectiveselection menu (Fig. 563).In the Change Objective area open one of theavailable directories of Favorite Objectives (showingall the objectives that have been previouslyselected), User Defined Objectives (showing all theobjectives that have been previously defined by anuser) (Fig. 562) or Potential Objectives (showing allobjectives listed in the used ZEN database).Expanding the field opens the respective objectivelist directory (Fig. 564). An expansion triangle isonly available, when objectives are available in therespective directory (Fig. 562). The scroll bars allowhaving access to all entries in the list.• Select the correct objective by highlighting it.Press the Select Objective button. Note thatthe button becomes only active, if an objectivewas selected. The Name of the objective willappear at the corresponding position.• Click anywhere outside the expansion windowto close it.Fig. 562 Objective selectionFig. 563 Objective selection – User DefinedObjectives with empty directoryFig. 564 Objective selection – PotentialObjectives directory
