Panasonic MICRO-IMAGECHECKER PV310 Use Manual

Also see for Micro-Imagechecker PV310: Brochure & specs

142Setting CheckersChapter 66.13 Position Adjustment (Binary Edge)6.13.1 Setting ProcedureThe procedures for detecting and setting edges in vertical and horizontal search areas are almost the same asthose used for "Binary Edge". (See page 96.) In this section, the functional differences between PositionAdjustment (Binary Edge) and Binary Edge are described.PriorityThe Priority function is effective if an object moves largely either vertically or horizontally. When the object moveslargely in the horizontal direction, set “Priority” to "Horizontal". When it moves largely in the vertical direction, set“Priority” to "Vertical".Different condition for each areaDifferent condition to detect an edge can be set for horizontal area and vertical area. However, the following itemsmust be set the same.• Camera• Preprocess• Position AdjustmentRunning a test Uising Horizontal /Vertical Search AreasBefore saving a base position, you can perform a test to check whether or not edges were detected in a verticalor horizontal search area. When a live image is currently displayed, capture a new image first and begin the test.When a memory image is displayed, run a test using the currently displayed memory image without capturing anyimages.1. Select “POS. ADJ. (EDGE)”.2. Press the A key while the tab or item under the tab is highlighted.If no edge is detected, the following error code will appear in the message area.E0044Check to make sure that the error code does not appear or that the edges were detected.