Panasonic MICRO-IMAGECHECKER PV310 Use Manual

Also see for Micro-Imagechecker PV310: Brochure & specs

237Environment Settings Chapter 99.4.4 Behavior When Ethernet Communication ErrorWhen image output through Ethernet failed, the behavior of PV310 is selectable.Condition of “Communication error”This “Communication error” indicates the situation that the device fails to output images correctly because of thefollowing conditions.• Trouble in LAN cable (such as disconnection or loose connection)• Image Receiver is not activated.BehaviorsYou can select the following behaviors including taking no action. Both Error signal output and forced outage areavailable at the same time.1 None Takes no action specially. Ends inspections in the same way as successfulimage output.2 ERROR Signal Output Outputs an error signal through parallel I/O.3 Forced Outage Aborts inspections. When “Output operation” is set to “Synchronous”, you canretransfer the image that is failed to output by keypad operation.ERROR Signal OutputOut puts an error signal through parallel I/O.Timing of Error Signal Reset (OFF)Output operation Timing of Reset (OFF)Outputting error signal singularly“Forced outage” without imageretransmissionDepends on “Parallel Reset Condition”.“Forced outage” with image retransmission Turns off the error signal when the image is retransmitted.When retransmission was not completed correctly, outputs anerror-signal again and shows the same message.