66Procedure for Setting Inspection ConditionsChapter 55.8 Executing Inspection5.8.1 Procedure for Inspection ExecutionExecute inspection according to your settings.1. Switch to RUN mode.Keep pressing the C key until the menu bar disappears.2. Press the A key.Inspection is started, and the total judgment results or status of the signal output from terminal block aredisplayed in the status display area at the left side of the monitor screen. At this time, even if START signalis input or the serial commands for inspection are sent from the external device, the total judgment result orthe output status of the signal is displayed in the status display area.