Panasonic MICRO-IMAGECHECKER PV310 Use Manual

Also see for Micro-Imagechecker PV310: Brochure & specs

50Basic OperationChapter 43. Set the end position (the black square mark on the rectangle) of the circle.Move and position the start point by tilting the ENTER key in the desired direction. Press the C key to goback to the previous step.Drawing a CircleFollow the steps below to set the start and end points of the circumscribing rectangle after displaying a checkershape on the screen by selecting “Change”. If you want to draw a circle or an ellipse with the Flaw Detectionfunction, refer to section 6.11, “Flaw Detection” on page 129.1. Move the whole circle.Move the whole circle by tilting the ENTER key in the desired directionand press the ENTER key to fix the position.2. Fix the start point (the white square mark on the circumscribing rectangle).Move the circumscribing rectangle by tilting the ENTER key in thedesired direction and press the ENTER key to fix the position. Press theC key before pressing the ENTER key to go back to the previous step.3. Set the end position (the black square mark on the circumscribing rectangle) of the circle.Move the end point by tilting the ENTER key in the desired direction andpress the ENTER key to fix the position. Press the C key beforepressing the ENTER key goes back to the previous step.