Panasonic MICRO-IMAGECHECKER PV310 Use Manual

Also see for Micro-Imagechecker PV310: Brochure & specs

305Chapter 13 Using a Compact Flash Memory Card13.5 Outputting the Inspection Results to a Compact Flash MemoryCardThis feature outputs the inspection results to a Compact Flash memory card. But, if this function is used duringinspection, the following problems occur. Use the function only for test execution and test run. Never use it duringinspection execution.• It takes too much time to write the inspection result data on the Compact Flash memory card.• The amount of the data stored in the Compact Flash memory card became large during continuouslongtime run, resulting in shortage of capacity.Data Stored in a CF CardThe data in the table below can save in the Compact Flash memory card when inspection is executed.The data of the items that have been set to output are output in the orders described below by selecting“ENVIRONMENT” > “Data Output Settings” > “General Output” from the menu bar.Output Output Order1. Number of scans2. Judgment results (up to 96 data)3. Numeric calculation data (up to 96 data)Output data fromPV310 duringinspection4. Statistics data (up to 96 data)Output SettingsIn the following cases, the data of each of Scans, Numeric Calculation, and Statistics are not output to the CompactFlash memory card (unset registers are skipped.)• Each data is set to “Out” under the “General Output” tab, but the setting data do not exist.• The setting data exist, but each data is set to “None” under the “General Output” tab.The data are output in the same format as that used for RS-232C communication (see page 260).Destination FileThe output data are saved as the following text file.RES20050112.txt RES: Fixed20050112: Variable. This is the date when the data were output and it uses theinformation on Calendar settings stored in PV310. The date information isupdated only when PV310 is turned on. Thus, if the day changes withoutturning off the PV310, it keeps on outputting the data to the file with the lastupdated date.To output inspection results to a Compact Flash Memory card:1. Select "ENVIRONMENT" > "Data Output Settings" > "Output Settings" from the menu bar.2. Select "Card".If the Compact Flash memory card does not have enough storage capacity to save the setting or image data, nomore images are saved. Note that no message saying you failed to save the image is displayed or no signals areoutput.