Panasonic MICRO-IMAGECHECKER PV310 Use Manual

Also see for Micro-Imagechecker PV310: Brochure & specs

159Setting CheckersChapter 66.20.2 Saving a Base PositionThe procedure for saving the current object position as a base position is described below. Before saving a baseposition, set inspection conditions first and check to make sure that the object was detected after testing. When alive image is displayed, a base position is saved after capturing a new image. When a memory image isdisplayed, the current memory image is saved as a base position without importing any image.Registration Procedure1. Select the “Base Position” tab.The cursor moves to "Base Setting".2. Press the ENTER key.When the dialog message shown below appears, choose "YES" tocontinue.If the object is correctly detected and the base position was saved, thefollowing information appears.Under the Base Position tabAdj. X: 0.0Adj. Y: 0.0Adj. Theta: 0.0Base Pos. X: Coordinate XBase Pos. Y: Coordinate YBase Pos. Theta: AngleIn the Message areaJudgment: OKAdj. X: 0.0Adj. Y: 0.0Adj. Theta: 0.0If the PV310 failed to detect the object, the following message appears. Check the setting values for Area,Max. /Min. Area Limits. or the inspection objects.E0042 Base position cannot be detected.6.20.3 What To Do If You Faced a TroubleJudgment result is always NG.This is attributed to the following causes.The object could not be detectedRecheck and reconsider the area size and the inspection conditions (Target, Filter, Width and Priority).No base position is saved.The error code "E0049" may be displayed. Since any base position is not saved, the PV310 cannot workproperly. Note that if you change area position, size or shape after saving it, you need to save the baseposition again.Position Adjustment checker that refers to adjustment amount cannot detect the object.If Position Adjustment is saved as any number except "0", the adjustment amount of Position Adjustmentor Rotation Adjustment that is saved as the number is referred. If the Position Adjustment or RotationAdjustment checker failed to refer to the adjustment amount, it cannot detect the object. The PV310 doesnot function properly and outputs "NG" result.