| 
9W006 and 9W007 111SYSTEM M ESSAGESSystem Message Summary # 0000: Error reading platform type: there is no “plat name” fieldThere is no value following the “=” character in the “current setting” string. # 0000: Error reading platform type: there was no “=” in the stringThe “current setting” string has the format “=”. This error messageindicates that no “=” character exists in the string. # 0000: Error reading platform type: type value is too largeThe value in the “current setting” string is too large to represent an actual platformtype. # 0000: Error reading platform type: type was not converted to an intThe value in the “current setting” string could not be converted to an actualplatform type.1 port LAN Adapter, operating in remote mode onlyThis is an initialization message. It identifies the Ethernet adapter type (Ethernet-1), and operatingmode. Remote bridging is supported.2 port LAN Adapter, operating in local and remote modeThis is an initialization message. It identifies the Ethernet adapter type (Ethernet-2), and operatingmode. Both local and remote bridging are supported.aarp found duplicate AppleTalk address @ The address resolution protocol found duplicate AppleTalk addresses for this AppleTalk network.Check the configuration for the AppleTalk ports’ network range/number.Abnormal response rcvd: An unexpected message was received from a WAN interface card. The included arefor problem reporting purposes only. If the system fails to operate normally, or the warningcontinues to occur, contact your Distributor or Customer Support.A call has exceeded the configured maximum durationA call has been up longer than the amount of time configured. The next log message will informthe user whether or not the call has been taken down.ACE authentication is not available. You must first ENABLE ACE user level authentication.An attempt was made to configure the Terminal Server Security for ACE and ACE was notconfigured on the SmartSwitch Remote Access Module.Adapter does not respond: adapter # ’x’The WAN card initialization subsystem encountered an error on the indicated adapter. Restart thesystem. If the problem persists, the indicated adapter card may be faulty and you should contactyour Distributor or Customer Support.Adapter # ’x’ failed to initializeThe operational software on the indicated adapter card failed to signal that initialization wascompleted. Restart the system. If the problem persists, the indicated adapter card may be faulty andyou should contact your Distributor or Customer Support. |
