USER’S GUIDE96 SmartSwitch Remote Access ModuleAction:1. Verify triggered RIP/SAP has successfully started for peers. Issue thedr console commandand look for the “starting” message in the log.2. Generate a triggered RIP/SAP update request to the devices in question. Issue the followingconsole command for each device:ipx trigreq 3. Verify that the statistics are incremented properly. Issue the following console commands:ipx trigrip statsipx trigsap stats4. If routes/services are not propagated on either side, contact Customer Support.A PPLE T ALK R OUTINGThis section provides methods for diagnosing problems in the following areas of AppleTalkrouting:• AppleTalk routing initialization• AppleTalk routing over the LAN connection• AppleTalk routing over the WAN connectionUse the following example configuration to diagnose AppleTalk routing operational problems. Theexample below uses AppleTalk addresses, zones, and resource names specific to the example.Substitute those of your network when you perform the diagnosis steps.APPLE TALK ROUTING I NITIALIZATIONProblem:The SmartSwitch Remote Access Module does not display the correct AppleTalk RoutingInitialization messages.ISDNCSX1200"Site2"Net Range: 10-11Zone: Left ZoneNet Range: 20-21Zone: Right ZoneLocal Mac Remote MacMMAC PLUSC a b l e t r o nSystemsMMAC-Plus withSmartSWITCHRemote Access Module"Site 1"WORKGROUP REMOTE ACCESS SWITCHLAN10BASE-TRXTXSERVICE CH-2D-CHCH-1SYNCPOWERLINE1CH-2D-CHCH-1SYNCLINE2CH-2D-CHCH-1SYNCLINE3CH-2D-CHAGICH-1SYNCLINE4
