USER’S GUIDE260 SmartSwitch Remote Access ModuleACK Packets SentDisplays the total number of ACK Packets sent.ACK Packets ReceivedDisplays the total number of ACK packets received.TFTP Sessions OpenedDisplays the total number of TFTP Sessions that have been opened.TFTP Sessions ClosedDisplays the total number of TFTP Sessions that have been closed.TFTP Sessions still openDisplays the total number of TFTP Sessions that are still open.UDP S TATISTICSIf the IP operating mode is enabled, you can access the following UDP statistics by using theudpstats command:udpInDatagramsThe total number of UDP datagrams delivered to UDP devices.udpInErrorsThe number of received UDP datagrams that could not be delivered for reasons other than the lackof an application at the destination port.udpNoPortsThe total number of received UDP datagrams for which there was no application at the destinationport.udpOutDatagramsThe total number of UDP datagrams sent from this system.WAN L1P S TATISTICSYou can access WAN L1P statistics by issuing thewan l1p stats display #> console command. These statistics are divided into the following groups of statistics:PRI S/T (T1/E1) interface statistics, error statistics, and layer 1 general statistics. These groups aredefined below.PRI S/T (T1/E1) I NTERFACE STATISTICSLayer 1 UpThe number of times layer 1 has reported itself up to the upper ISDN layers.Layer 1 DownThe number of times layer 1 has reported itself down to the upper ISDN layers.
