9W006 and 9W007 49ACCESSING THE SMART SWITCH R EMOTE ACCESS M ODULERemote Access using TelnetACCESSING THE RELEASE NOTESThe Release Notes provide release highlights and important information related to this release thatshould be reviewed before you begin the system’s configuration.The release notes are in a file called REL_NOTE.TXT. To display the release notes on the system,enter the following command at the system prompt:[system name]> LIST REL_NOTE.TXTR EMOTE A CCESS USING TELNETYou will use Telnet to remotely access the module for routine system management once initialinstallation and configuration has been performed. The same instructions given in Initial AccessUsing Telnet can be followed here with one exception, instead of Telneting into the module’s initialdefault IP address, you will Telnet to the new IP address you have configured for the module.You will need to establish an administration session so that you can issue console commands. Onceconnected, you will be prompted for a login id. Enter:adminYou will then be prompted to enter your password. If you have not yet changed the defaultpassword, enter:adminIf you have already configured a new password, enter the new password instead.
