USER’S GUIDE44 SmartSwitch Remote Access ModuleI NSTALLATION1. Note that the module is a double wide module and will fill two SmartSwitch 9000 slots.Remove the SmartSwitch 9000’s back panels that are covering the two slots into which themodule will be installed. To ensure proper airflow and cooling, all other empty slots must becovered.2. Before installing the SmartSwitch Remote Access Module into the chassis, ensure that thebottom and top plastic tabs are unlocked.3. Slide the module into the available slots making sure that the module is between the guides asshown in the following illustration. Check both the upper and lower tracks. Take care that themodule slides in straight and engages the backplane connectors properly.4. Lock down the top and bottom plastic tabs at the same time, applying even pressure.C ONNECTING THE M ODULE’S CABLINGInstalling the module into the SmartSwitch 9000 automatically completes its power supply andSMB connections. As you slide the module into place, the module’s power supply and SMBconnectors slide into the SmartSwitch 9000’s power supply and its SMB-1 BUS. What you will needMMAC PLUSMMAC PLUSC a b l e t r o nSystems11223 4Ejector TabsJack for ESDWrist StrapCircuit CardCard GuidesMetal Back Panel
