9W006 and 9W007 213S YSTEM COMMANDSCall Restriction CommandsIn response to thedisc device command, one of the following responses will be displayed:Disconnecting Indicates that the disconnect process has been initiated for the indicated device.No active connection to name>Indicates that the device that you are attempting to disconnect has no active connection.Themc or thecs command can be used to view the active connections. name> could not be found in the Device TableIndicates that the device name could not be found in the table of configured device names.More than one match for found in the Device TableDisplayed if you enter just part of a device name and that part could specify more than onedevice name. You will be prompted to enter the device name again, in a more specificmanner. For example, ifcall device Sch is entered, and there is a device configuredwith the name Schultz, and a device configured with the name Schmidt, this messagewould be displayed. You would then need to enter at leastcall device Schu tosuccessfully initiate a call to the device Schultz.Re-enter the name, or to cancelThe device name must be re-entered.Unable to prompt for device name at this timeIndicates that thecall command would prompt you for a device name, but the necessaryresources are not available. The recommended actions are as follows:1. If possible, enter the device name on the command line.2. If the device name cannot be entered from the command line (for example, the devicename contains command line delimiters of a space, a comma, a colon, or a tab), thedevice can wait for a few minutes and see if any resources become available.3. If actions 1 and 2 are ineffective, this may indicate an internal problem in the System,please inform your service representative of the occurrence.C ALL R ESTRICTION C OMMANDSWhen the Call Restriction feature is enabled on the SmartSwitch Remote Access Module, thefollowing command is available through the administration console:cr statsDisplays the current Call Restriction statistics. Refer to Call Restriction Statistics, for a list ofavailable statistics and their definitions.
