9W006 and 9W007 45HARDWARE I NSTALLATIONConnecting the Module’s Cablingto complete, though, is the Ethernet and PRI cabling. In addition, U.S. and European installationsneed a Mod-Tap adapter for each PRI port. Instructions for each are included below.M ODULE TO S MARTS WITCH 9000 ETHERNET CABLINGWe supply two Ethernet cables with the module. You will use these cables to connect the module’sEthernet interface(s) to the SmartSwitch 9000’s Ethernet connection, providing the module withLAN connectivity. To complete the Ethernet cabling:1. Refer to the illustration of the 9W0006-400 for the Ethernet ports’ locations.2. Insert the RJ-45 adapter at one end of the provided Ethernet cable into the module’s Ethernetport 1.3. Insert the RJ-45 adapter at the other end of the Ethernet cable into one of the SmartSwitch 9000’sEthernet ports.4. Repeat steps 2 and 3 for Ethernet port 2 if you will be using a second Ethernet connection.M OD -TAP ADAPTERThe cabling between the wall jack and the module is very important, and is also where mostproblems occur. The system's PRI RJ-45 adapter uses the international standard of pins 3, 4, 5, and6 for transmit and receive. Most T1 lines in the United States and Europe use the traditional 1, 2, 4,and 5 pins. We provide an RJ-45 to RJ-45 Mod-Tap adapter that will convert between the twowiring systems.For non-U.S. and European installations, standard cabling is sufficient (refer to following section).M ODULE TO PRI SERVICE CABLINGThe PRI cabling is not included with your module. You will need to determine the length of cableyou need for your connection. The PRI cabling is the same type as the Ethernet cabling: straight-through twisted-pair cable with RJ-45 adapters at each end. To complete the PRI cabling:RJ-45PinoutAdapterRJ-45Pinout12345678inserts intoPRI port12345678TX+RX+RX-TX-RX+RX-TX+TX-Mod-TapAdapterinsert one end of PRI cable here,other end into PRI service drop
