| 
USER’S GUIDE222 SmartSwitch Remote Access ModuleLAN C OMMANDSThe following commands are used to display current system LAN diagnostic information:lan statsDisplays the current LAN packet forwarding statistics, including the number of framesreceived and transmitted from LAN and WAN connections. Refer to LAN Statistics, for a list ofavailable statistics and their definitions.lan stat clearClears the current LAN packet forwarding statistics.lan testTransmits a test message onto the LAN and test for proper LAN connections. If the transmit issuccessful, the following message will be displayed:LAN port #> Transmit was successfulIf the transmit fails, refer to the section titled LAN Attachment to determine the reason for thefailure.P ACKET C APTURE C OMMANDSIn many applications, it is often desirable to monitor incoming LAN data. Thepkt commandswill allow you to capture, display, save, and load bridged or routed data packets.You must configure the terminal setting the same for Telnet and the terminal emulation package.To do this, use theterm set command.Note: Packet capture commands are available for both local and remote (Telnet) connections.The following diagnostic packet commands are available:pkt [on/off]Enables or disables the Packet Capture feature.pkt capture [all/idle/reqd/pend/actv/none]Specifies which packets will be captured by the Packet Capture feature. A definition of eachpossible parameter follows.allAll packets will be captured.noneNo packets will be captured.reqdOnly packets causing a connection to be requested will be captured.pendOnly packets received while a requested connection is pending will be captured. |
