9W006 and 9W007 59S YSTEM VERIFICATIONVerifying IP Routing Over InterfacesThe steps to verify the operation of IP routing over a WAN interface are:1. Determine if a remote IP host can access the WAN interface of the SmartSwitch Remote AccessModule over the WAN connection. On the remote IP host, type:ping 192.100.1.1 If the remote IP host successfully pings to the SmartSwitch Remote Access Module, thencontinue with the next step.If the remote IP host CANNOT ping to the system, refer to IP Routing Over a WAN InterfaceConnection in the Problem Diagnosis chapter.2. Determine if a remote IP host can access the LAN interface of the SmartSwitch Remote AccessModule over the WAN connection. On the remote IP host type:ping 100.0.0.1 If the remote IP host successfully pings to the SmartSwitch Remote Access Module, thencontinue with the next step.If the remote IP host CANNOT ping to the SmartSwitch Remote Access Module, refer to IPRouting Over a WAN Interface Connection in the Problem Diagnosis chapter.3. Determine if a remote IP host can access the local IP host through the system over the WANconnection. On the remote IP host type:ping 100.0.0.2 If the remote IP host successfully pings to the local IP host, then IP routing over WAN typeinterface is operational. Repeat the above steps for each WAN type interface through whichyou wish to get access.192.100.1.1100.0.0.1100.0.0.0Host A100.0.0.2Host B192.100.1.3ISDNMMAC PLUSC a b l e t r o nSystemsMMAC-Plus withSmartSWITCHRemote Access Module
