• Individual pull control fields with pullup, pulldown, and pull-disablesupport onselected pins• Individual drive strength field supporting high and low drive strength on selectedpins• Individual slew rate field supporting fast and slow slew rates on selected pins• Individual input passive filter field supporting enable and disable of theindividual input passive filter on selected pins• Individual mux control field supporting analog or pin disabled, GPIO, and up tosix chip-specific digital functions• Pad configuration fields are functional in all digital Pin Muxing modes11.2.2 Modes of operation11.2.2.1 Run modeIn Run mode, the PORT operates normally.11.2.2.2 Wait modeIn Wait mode, PORT continues to operate normally and may be configured to exit theLow-Power mode if an enabled interrupt is detected. DMA requests are still generatedduring the Wait mode, but do not cause an exit from the Low-Power mode.11.2.2.3 Stop modeIn Stop mode, the PORT can be configured to exit the Low-Power mode via anasynchronous wakeup signal if an enabled interrupt is detected.11.2.2.4 Debug modeIn Debug mode, PORT operates normally.11.3 External signal descriptionThe following table describes the PORT external signal.External signal descriptionKL25 Sub-Family Reference Manual, Rev. 3, September 2012176 Freescale Semiconductor, Inc.
