Chapter 6: Using the Web Interface963. In the Detection Mode field, select the way to display connectedLHX/SHX heat exchangers. Disabled: When applied, disables to port and nothing connectedto the port is detected. Auto: An icon is displayed for this port only when the EMX devicedetects the physical connection of the LHX/SHX heat exchangeron this port. Otherwise, nothing is displayed. This is the defaultapproach. Pinned: An icon is displayed for this port all the time, but the iconimage varies according to the connection status. See DeviceStates and Icon Variations (on page 280).When the Pinned checkbox is selected, click the drop-downarrow to select the appropriate device type for this port: LHX-20,LHX-40 or SHX-30.4. Click OK.In the tree, the icon, if present, is followed by the device name ifavailable, device type and the port number or FEATURE port (ifapplicable).Setup ButtonThe Setup button is available for most tree items. It triggers a setupdialog where you can change settings for the selected tree item.Status BarThe status bar shows five pieces of information from left to right. Device name:This is the name assigned to the EMX device. The default is "EMX."See Naming the EMX (on page 110). IP address:The numbers enclosed in parentheses is the IP address assigned tothe EMX device. See Initial Network Configuration via CLI (onpage 15) or Modifying Network Settings (on page 114).Tip: The presence of the device name and IP address in the statusbar indicates the connection to the EMX device. If the connection islost, it shows " " instead.