Chapter 8: Using the Command Line Interface422USB-Cascading Configuration CommandsA USB-cascading configuration command begins with cascading. Youcan set the cascading mode on the master device.Note: You CANNOT change the cascading mode on slave devices.Configuring the Cascading ModeThis command determines the cascading mode.config:# cascading mode Variables: is one of the following cascading modes:Mode Descriptionbridging The network bridging mode, where eachcascaded device is assigned a unique IPaddress.portForwarding The port forwarding mode, where everycascaded device in the chain shares thesame IP address, with diverse portnumbers assigned.Asset Management CommandsYou can use the CLI commands to change the settings of the connectedasset sensor (if any) or the settings of LEDs on the asset sensor.Asset Sensor ManagementAn asset sensor management configuration command begins withassetStrip.
