Chapter 3: Installation and Configuration103. Connect the other end of the power cord to an appropriate powersource.Configuring the EMXYou can initially configure the EMX by connecting it to a computer, or toa TCP/IP network that supports DHCP.Configuration over a DHCP-enabled network:1. Connect the EMX to a DHCP network. See Connecting the EMX toYour Network (on page 14).2. Retrieve the DHCP-assigned IPv4 address. Use the front panel LCDdisplay to retrieve it. See IPv4 Address (on page 72).3. Launch a web browser to configure the EMX. See Login (on page84).Configuration using a connected computer:1. Connect the EMX to a computer. See Connecting the EMX to aComputer (on page 11).2. Use the connected computer to configure the EMX via the commandline or web interface. Command line interface: See Initial Network Configuration viaCLI (on page 15). Web interface: Launch the web browser on the computer, andtype the link-local IP address or pdu.local to access the EMX.See Login (on page 84). For IP address retrieval, see IPv4Address (on page 72).Tip: To configure a number of EMX devices quickly, see BulkConfiguration Methods (on page 21).
