Chapter 6: Using the Web Interface267Viewing Webcam Snapshots or VideosYou can switch between snapshots or live videos being captured by awebcam.The snapshot or video is displayed either in the EMX web interface or ina Primary Standalone Live Preview window that you open.You can open a maximum of five Primary Standalone Live Previewwindows.Note: For remote Live Preview sessions, such as those accessed via alink in an email or instant message, a total of up to three (3)simultaneous Live Preview sessions are supported at a time. One (1)from the originator in the EMX interface, and up to two (2) remotesessions. See Sending Snapshots or Videos in an Email or InstantMessage (on page 269).To switch between snapshot and video modes:1. Click the desired webcam's icon in the navigation tree.Snapshots or videos captured by the webcam are displayed in theright pane of the EMX web interface once a webcam is selected inthe navigation tree.Snapshots and videos can also be displayed in Live Preview mode inthe Primary Standalone Live Preview window by clicking on the LivePreview icon .Note: All Live Preview sessions sharing the same URL, including onePrimary Standalone Live Preview window and two associated remotesessions, are identified as one single "" user in theConnected Users dialog. You can disconnect a "" userfrom this dialog to terminate a specific Primary Standalone LivePreview window and all of its remote sessions. See ViewingConnected Users (on page 234).2. By default the EMX enters the snapshot mode. Wait around oneminute for the snapshot to appear.In the snapshot mode, three pieces of information are displayed onthe top of the image: A snapshot mode icon . The interval time between snapshots (in seconds). A time stamp.The webcam's location information, if available, is displayed in theLocation pane of the EMX web interface.
