Chapter 6: Using the Web Interface265a. Video - the webcam is in video mode. Set the Framerate (framesper second) rate.b. Snapshot - the webcam displays images from the webcam. Setthe "Time between Snapshots" rate as measured in seconds.7. Click OK. The image or video from the webcam is now available inthe EMX once you click on the webcam in the navigation tree.To edit a webcam configuration:1. In the navigation tree, click on the Webcam Management folder. TheWebcam Management page opens.2. Double-click on the webcam you want to edit. The webcam image orvideo opens in a new tab.3. Click Setup .4. Edit the information as needed. Changes to the resolution do notapply to existing, stored images - it applies only to images andvideos taken after the resolution is changed.5. Click OK.Configuring Webcam StorageOnce a snapshot is taken using the Store Snapshot to Webcam Storagefeature, it is stored locally on the EMX by default. Up to ten (10) imagescan be stored on the EMX at once.To save more than 10 snapshots, save the images on a CommonInternet File System/Samba.Note: NFS and FTP are not supported for this release and are disabledon the dialog.Snapshot files are saved as JPG files. The snapshot file is named basedon the number of the snapshot starting from 1. So the first snapshot thatis taken is named 1.jpg, the second is 2.jpg and so on.Unless snapshots are deleted manually, the oldest snapshot isautomatically deleted from the device when the number of snapshotsexceeds ten. Rebooting the EMX deletes all webcam snapshots that aresaved on the device.To configure another storage location for images:1. In the navigation tree, click Snapshots under the WebcamManagement folder. The Snapshots page opens.2. Click on the Setup Storage icon . The Storage Setup dialogopens.
