Chapter 8: Using the Command Line Interface337Clearing Event LogThis command removes all data from the event log.# clear eventlog-- OR --# clear eventlog /yIf you entered the command without "/y," a message appears,prompting you to confirm the operation. Type y to clear the event log or nto abort the operation.If you type y, a message "Event log was cleared successfully" isdisplayed after all data in the event log is deleted.Clearing WLAN LogThis command removes all data from the diagnostic log for the wirelessLAN (WLAN) connection.# clear wlanlog-- OR --# clear wlanlog /yIf you entered the command without "/y," a message appears,prompting you to confirm the operation. Type y to clear the WLAN log orn to abort the operation.If you type y, a message "WLAN log was cleared successfully" isdisplayed to indicate all data in the WLAN log has been deleted.Configuring the EMX Device and NetworkTo configure the EMX device or network settings through the CLI, it ishighly recommended to log in as the administrator so that you have fullpermissions.To configure any settings, enter the configuration mode. Configurationcommands are case sensitive so ensure you capitalize them correctly.