Chapter 7: Using SNMP305Security level Description"noAuthNoPriv" Select this if no authorization or privacy protocolsare needed."authNoPriv" Select this if authorization is required but noprivacy protocols are required. Select the authentication protocol - MD5 orSHA Enter the authentication passphrase and thenconfirm the authentication passphrase"authPriv" Select this if authentication and privacy protocolsare required. Select the authentication protocol - MD5 orSHA Enter the authentication passphrase andconfirm the authentication passphrase Select the Privacy Protocol - DES or AES Enter the privacy passphrase and then confirmthe privacy passphraseSNMP Gets and SetsIn addition to sending notifications, the EMX is able to receive SNMP getand set requests from third-party SNMP managers. Get requests are used to retrieve information about the EMX, suchas the system location. Set requests are used to configure a subset of the information, suchas the SNMP system name.Note: The SNMP system name is the EMX device name. When youchange the SNMP system name, the device name shown in the webinterface is also changed.The EMX does NOT support configuring IPv6-related parametersusing the SNMP set requests.Valid objects for these requests are limited to those found in the SNMPMIB-II System Group and the custom EMX MIB.
