Chapter 5: Using the EMX74Section Example informationThe word "MASTER" indicates the EMX is the masterdevice in a USB-cascading configuration. SeeCascading the EMX via USB (on page 22).Note: For a standalone EMX, this word is NOT displayed.For a slave device, it shows "SLAVE" instead.The LCD display is showing "03," which is part of theMAC address.To display the MAC address:1. Press the MODE button to enter the Device mode, indicated by a 'd'in at the top left of the display.2. Press the FUNC button until the MAC address is displayed. Thecharacter "M" appears in the left side of the LCD display.3. The MAC address is displayed as "M:XX", where XX are two digits ofthe MAC address. The LCD will cycle through the MAC address fromthe first two digits to the final two.For example, if the MAC address is 00:0d:5d:03:5E:1A, the LCDdisplay shows the following information one after another:M 00 --> M:0d --> M:5d --> M:03 --> M:5E --> M:1ANote that 'M' is NOT followed by the colon symbol when showing thefirst two digits of the MAC address.USB-Cascaded Device's PositionA cascaded device's position is available by operating the LCD display.For information on the USB-cascading configuration, see Cascading theEMX via USB (on page 22).Below illustrates a slave device's position.
