Chapter 8: Using the Command Line Interface3115. Type a password and press Enter. The password is case sensitive.After properly entering the password, the # or > system promptappears. See Different CLI Modes and Prompts (on page 313) inthe User Guide for more information.Tip: The "Last Login" information, including the date and time, is alsodisplayed if the same user profile was used to log in to this product'sweb interface or CLI.6. You are now logged in to the command line interface and can beginadministering the EMX.With SSH or TelnetYou can remotely log in to the command line interface (CLI) using anSSH or Telnet client, such as PuTTY.Note: PuTTY is a free program you can download from the Internet. SeePuTTY's documentation for details on configuration.To log in using SSH or Telnet:1. Ensure SSH or Telnet has been enabled. See Modifying NetworkService Settings (on page 120) in the User Guide.2. Launch an SSH or Telnet client and open a console window. A loginprompt appears.3. Type a name and press Enter. The name is case sensitive.Note: If using the SSH client, the name must NOT exceed 25characters. Otherwise, the login fails.Then you are prompted to enter a password.4. Type a password and press Enter. The password is case sensitive.5. After properly entering the password, the # or > system promptappears. See Different CLI Modes and Prompts (on page 313) inthe User Guide for more information.