Chapter 5: Using the EMX82For Raritan's DPX water sensors, the Normal state must be set toNormally Open (N.O). The following is the correct LED behaviorbased on proper dip switch settings.LED Sensor stateOff No water detectedLit Water detectedReset ButtonThe reset button is located inside a small hole which is labeled RESET.The EMX can be reset to its factory default values using this button whena serial connection is available. See Resetting to Factory Defaults (onpage 477).Without the serial connection, pressing this reset button only restarts theEMX software.BeeperThe EMX includes an internal beeper, which can issue an audible alarm.Note that the beeper does NOT sound an alarm unless an event ruleinvolving the internal beeper has been created and turned on the internalbeeper accordingly. See Event Rules and Actions (on page 187).Tip: You can remotely check this beeper's state via the web interface.See Checking the Internal Beeper State (on page 148).