Chapter 6: Using the Web Interface268 To change any image settings, click Setup . SeeConfiguring Webcams (on page 264) or Adjusting ImageProperties (on page 266). To save the snapshot being displayed, click the "Store Snapshotto Webcam Storage" icon . See Saving Snapshots (onpage 268).3. To switch to the video mode, click Setup and select Video in theWebcam Mode field.In the video mode, two pieces of information are displayed on the topof the image: A video mode icon . The number of frames to take per second (fps).To change any video settings, click Setup .4. To return to the snapshot mode, repeat the above step and selectSnapshot.Saving SnapshotsIf it is intended to keep the snapshot being displayed on the webcam,you can manually save it onto the EMX. A snapshot is saved as a JPEGfile and stored on the Snapshots page.Warning: The snapshots stored on the EMX are cleared whenrebooting the EMX. Check the importance of the snapshots beforeperforming the reset.To save the snapshot being displayed:1. In the navigation tree, click on the webcam you want to take asnapshot with. The webcam image is displayed in the right pane.The webcam must be in snapshot mode in order to take snapshots. Ifthe webcam is in video mode, click Setup in the right pane above thevideo image to open the Webcam Setup dialog, then select theSnapshot radio button.2. Once the snapshot image being taken by the selected webcam isdisplayed in the right pane, click the Store Snapshot to WebcamStorage icon above the image to take a snapshot. Up to ten (10)snapshots can be stored at once on the device.
