1034 CHAPTER 73: BGP DEBUGGING COMMANDS// Information about the sent VPLS update message*0.92566 Sysname RM/7/RMDEBUG:BGP.VPLS: Recv UPDATE from 1.1.1.1 with following destinations :Update message length : 88Origin : IGPAS Path : 100Next Hop : 1.1.1.1afi = 155(vpls) safi = 128(vpls)Route Distinguisher:100:1CE-ID:0label offset:0label base:8192// Information about the received VPLS update messagedebugging bgp update vpn-instanceSyntax debugging bgp update vpn-instance vpn-instance-name [ ip-prefix ip-prefix-name |peer { ipv4-address | group-name } ] [ receive | send ] [ verbose ]undo debugging bgp update vpn-instance vpn-instance-name [ ip-prefixip-prefix-name | peer { ipv4-address | group-name } ] [ receive | send ] [ verbose ]View User viewDefault Level 1: Monitor levelParameters vpn-instance-name: Enables/disables the BGP update message debugging for thespecified VPN instance.ip-prefix ip-prefix-name: Filters the output message debugging information withthe specified IP prefix list.peer { ipv4-address | group-name }: Enables/disables BGP update messagedebugging for the specified peer/peer group.receive: Enables/disables the debugging for received BGP packets.send: Enables/disables the debugging for the sent BGP packets.verbose: Displays detailed debugging information.Description Use the debugging bgp update vpn-instance command to enable updatemessage debugging for a BGP VPN instance.Use the undo debugging bgp update instance command to disable updatemessage debugging for a BGP VPN instance.By default, this debugging is disabled.Enabling debugging may affect system performance; therefore, use this commandonly when necessary and disable debugging once the debugging operation iscomplete.
