2282 CHAPTER 149: NQA C LIENT CONFIGURATION COMMANDS[Sysname-nqa-admin-test-tcp] reaction 1 checked-element probe-failthreshold-type consecutive 3 action-type trigger-onlyreaction trapSyntax reaction trap { probe-failure consecutive-probe-failures | test-complete | test-failurecumulate-probe-failures }undo reaction trap { probe-failure | test-complete | test-failure }View Any NQA test type viewParameter probe-failure consecutive-probe-failures: Specifies to send a trap to the networkmanagement server after consecutive-probe-failures in an NQA test.consecutive-probe-failures is the number of consecutive probe failures in a test, inthe range 1 to 15.test-complete: Specifies to send a trap to indicate that the test is completed.test-failure cumulate-probe-failures: Specifies to send a trap to the networkmanagement server if the total number of probe failures in an NQA test is largerthan or equal to cumulate-probe-failures. For one test, the trap is sent only whenthe test is completed. cumulate-probe-failures is the total number of consecutiveprobe failures in a test, in the range 1 to 15.Description Use the reaction trap probe-fail command to configure to send traps tonetwork management server under specified conditions.Use the undo reaction trap probe-fail command to restore the default.By default, no traps are sent to the network management server.Example # Configure to send a trap after five consecutive probe failures in an ICMP-echotest. system-view[Sysname] nqa entry admin test[Sysname-nqa-admin-test] type icmp-echo[Sysname-nqa-admin-test-icmp-echo] reaction trap probe-failure 5route-option bypass-routeSyntax route-option bypass-routeundo route-option bypass-routeView DLSw/FTP/HTTP/ICMP-echo/SNMP/TCP/UDP-echo/UDP-jitter test type viewParameter None
