700 CHAPTER 48: ARP SOURCE SUPPRESSION CONFIGURATION COMMANDSDescription Use the arp source-suppression limit command to set the maximum numberof packets with the same source IP address but unresolvable destination IPaddresses that a port can receive in five seconds.Use the undo arp source-suppression limit command to restore the defaultvalue, which is 10.Related command: display arp source-suppression.Example # Set to 100 the maximum number of packets with the same source address butunresolvable destination IP addresses that a port can receive in five seconds. system-view[Sysname] arp source-suppression limit 100display arp source-suppressionSyntax display arp source-suppressionView Any viewParameter NoneDescription Use the display arp source-suppression command to display informationabout the current ARP source suppression configuration.Example # Display information about the current ARP source suppression configuration. display arp source-suppressionARP source suppression is enabledCurrent suppression limit: 100Current cache length: 16Table 125 Description on fields of display arp source-suppressionField DescriptionARP source suppression isenabledThe ARP source suppression function is enabled.Current suppression limit Maximum number of packets with the same source IPaddress but unresolvable IP addresses that the device canreceive in five secondsCurrent cache length Size of cache used to record source suppression information
