555display bridge informationSyntax display bridge information [ bridge-set bridge-set ]View Any viewParameters bridge-set: Bridge set number, an integer in the range of 1 to 255.Description Use the display bridge information command to view the information aboutthe specified bridge set or all bridge sets.Example # View the information about all bridge sets. display bridge informationBridge module is activated,2 port take part in bridge module at all;Address table has 15 item, with 1 static one; life cycle is 300 (s).Bridge set 1 :configure :bridge 1 enable;bridging ip, undo bridging ipx; bridging others;undo routing ip, undo routing ipx;bridge 1 learninginterface :total 2 interface(s) in the setEthernet1/0 : upEthernet1/1 : upBridge set 2 :configure :bridge 2 enable;bridging ip, undo bridging ipx; bridging others;undo routing ip, undo routing ipx;bridge 2 learninginterface :total 2 interface(s) in the setEthernet1/0.1 :upEthernet1/0.2 :upSet Bridge set numberFlag Flag can be any of the four values: P--PERMIT N--DENYD--DYNAMIC S--STATICP: The permit rule is used for MAC address filteringN: The deny rule is used for MAC address filteringD: This entry is a dynamic entryS: This entry is a static entryAging-time The aging time of bridge table entriesReceive Number of received frames destined for this MAC addressSend Number of forwarded frames destined for this MAC addressInterface-name Outbound interface nameTable 90 Description on the fields of the display bridge address-table commandField Description
