2465 system-view[Sysname] user-interface vty 0 4[Sysname-ui-vty0-4] authentication-mode scheme[Sysname-ui-vty0-4] protocol inbound sshredirect disconnectSyntax redirect disconnectView User interface viewParameter NoneDescription Use the redirect disconnect command to manually terminate a redirected telnetconnection.n ■ The redirect commands are supported on the AUX and TTY user interfacesonly.■ Execute the command after using the redirect enable command to enableredirection on the user interface.Example # Manually terminate a redirected Telnet connection. system-view[Sysname] user-interface tty 1[Sysname-ui-tty1] redirect disconnectredirect enableSyntax redirect enableundo redirect enableView User interface viewParameter NoneDescription Use the redirect enable command to enable redirection on the activeasynchronous serial interface.Use the undo redirect enable command to disable this function.By default, the redirection function is disabled.n ■ The redirect commands are supported on the AUX and TTY user interfacesonly.■ To use the redirection function or configure redirection-related parameters, usethis command to enable redirection on the user interface.
