2403161S YSTEM D EBUGGING COMMANDSdebuggingSyntax debugging { all [ timeout time ] | module-name [ option ] }undo debugging { all | module-name [ option ] }View User viewParameter all: All debugging functions.timeout time: Specifies the timeout time for the debugging all command. Whenall debugging is enabled, the system automatically executes the undo debuggingall command after the time. The value ranges from 1 to 1440, in minutes.module-name: Module name, such as ARP or ATM. You can use the debugging ?command to display the current module name.option: Specifies the debugging option for a specific module. Different moduleshave different debugging options in terms of their number and content. You canuse the debugging module-name ? command to display the currently supportedoptions.Description Use the debugging command to enable the debugging of a specific module.Use the undo debugging command to disable the debugging of a specificmodule.By default, debugging functions of all modules are disabled.Note the following:■ This command is intended for network administrators to diagnose networkfailure.■ Output of the debugging information may degrade system efficiency, especiallyduring the execution of the debugging all command. Therefore, use thecommand with caution.■ After finishing debugging, you can use the undo debugging all command todisable all the debugging functions.■ You must configure the debugging, terminal debugging and terminalmonitor commands first to display detailed debugging information on the
