1050 CHAPTER 74: IS-IS CONFIGURATION COMMANDSView Any viewParameters verbose: When this parameter is used, the area address advertised in a neighbor’sHello packet will be displayed. Otherwise the system displays only the summaryinformation.process-id: Specifies an IS-IS process ID, in the range of 1 to 65535.vpn-instance-name: Specifies a VPN instance name, in the range of 1 to 31characters.Description Use the display isis peer command to display IS-IS neighbor information.Besides all the information displayed using the display isis peer command, thedisplay isis peer verbose command displays neighbor area address, hold time ofUp state and direct interface’s IP address.Examples # Display detailed IS-IS neighbor information. display isis peer verbosePeer information for ISIS(1)----------------------------System Id: 0000.0000.0003Interface: Ethernet1/0 Circuit Id: 0000.0000.0003.01State: Up HoldTime: 8s Type: L1(L1L2) PRI: 64Area Address(es):10Peer IP Address(es): 192.168.0.3Uptime: 00:14:03Adj Protocol: IPV4display isis routeSyntax display isis route [ ipv4 ] [ [ level-1 | level-2 ] | verbose ] * [ process-id | vpn-instancevpn-instance-name ]View Any viewTable 239 Description on the fields of the display isis peer commandField DescriptionSystem Id System IDInterface Interface connecting to the neighborCircuit Id Circuit IDState StateHoldTime HoldtimeType Type of the neighborPRI DIS PriorityArea Address(es) The neighbor’s area addressPeer IP Address(es) Interface IP address of the neighborUptime Time being upAdj Protocol Adjacency protocol
