36 BRIDGING CONFIGURATIONCOMMANDSbridge aging-timeSyntax bridge aging-time secondsundo bridge aging-timeView System viewParameters seconds: Aging time of dynamic bridge table entries, in seconds, with an effectiverange of 10 to 1000000.Description Use the bridge aging-time command to configure the aging time of dynamicbridge table entries.Use the undo bridge aging-time command to restore the default setting.By default, the aging time of dynamic bridge table entries is 300 seconds.Example # Set the aging time of dynamic bridge table entries to 500 seconds. system-view[Sysname] bridge aging-time 500bridge bridge-set enableSyntax bridge bridge-set enableundo bridge bridge-set enableView System viewParameters bridge-set: Bridge set number, an integer in the range of 1 to 255.Description Use the bridge bridge-set enable command to enable a bridge set.Use the undo bridge bridge-set enable command to remove a bridge set.n ■ Before you can enable the bridge set feature, you need to enable bridging first.■ Other related configurations can take effect only if the bridging and bridge setfeatures are enabled. This command is required for bridge configuration.
