1298 CHAPTER 84: IPV6 OSPFV3 CONFIGURATION COMMANDS# Configure OSPFv3 process 100 to redistribute the routes found by OSPFv3process 160. system-view[Sysname] ospfv3 100[Sysname-ospfv3-100] import-route ospfv3 160log-peer-changeSyntax log-peer-changeundo log-peer-changeView OSPFv3 viewParameters NoneDescription Use the log-peer-change command to enable the logging on neighbor statechanges.Use the undo maximum load-balancing command to disable the logging.With this feature enabled, information about neighbor state changes of thecurrent OSPFv3 process will display on the configuration terminal.Examples # Disable the logging on neighbor state changes of OSPFv3 process 100. system-view[Sysname] ospfv3 100[Sysname-ospfv3-100] undo log-peer-changemaximum load-balancing(OSPFv3 view)Syntax maximum load-balancing maximumundo maximum load-balancingView OSPFv3 viewParameters maximum: Maximum number of load-balanced routes, in the range 1 to 8. Theargument being set to 1 means no load balancing is available.Description Use the maximum load-balancing command to configure the maximumnumber of load-balanced routes.Use the undo maximum load-balancing command to restore the default.Examples # Configure the maximum load-balanced routes as 6.
