1865undo dar protocol-statisticView Interface viewParameters time: Time interval between statistics actions , in minute, in the range 1 to 30. Bydefault, it is 5 minutes.Description Use the dar protocol-statistic command to enable DAR packet statisticsfunction.Use the undo dar protocol-statistic command to disable the function.With DAR packet statistics function, users can timely monitor the packet number,data stream volume, historical mean rate and historical maximum rate ofapplication protocol on each interface, thus to facilitate implementingcorresponding policies for the data streams.By default, the function is disabled.Examples # Enable DAR packet statistics function on the interface Ethernet1/0, and set theinterval to 7 minutes. system-view[Sysname] interface Ethernet 1/0[Sysname-Ethernet1/0] dar protocol-statistic flow-interval 7display dar informationSyntax display dar informationView Any viewParameters NoneDescription Use the display dar information command to display information about theDAR module.Examples # Display information about the DAR module. display dar informationMax session count : 65536Watched session count : 1000Table 494 Description on the fields of the display dar information commandField DescriptionMax session count The number of maximum sessionsWatched session count The number of watched sessions
