2620 CHAPTER 173: VO IP C ONFIGURATION COMMANDSRelated command: display version on page 2417, and display device on page 2251.c CAUTION: You can use this command to reset only the analog voice cards of SICand MIM. To reset digital voice card and FIC analog voice card, carry out thereboot slot slot-number command in system view.Example # Reset the voice card of slot 3. system-view[Sysname] voice-setup[Sysname-voice] vi-card reboot 3voice-setupSyntax voice-setupView System viewParameter NoneDescription Use the voice-setup command to enter voice view and enable voice services.Example # Enter voice view and enable voice services. system-view[Sysname] voice-setupvoip called-tunnel enableSyntax voip called-tunnel enableundo voip called-tunnel enableView Voice viewParameter NoneDescription Use the voip calledtunnel enable command to enable the tunnel function onthe called gateway.Use the undo voip calledtunnel enable command to disable the tunnelfunction on the called gateway.By default, the tunnel function on the called gateway is enabled.Related command: tunnel-on.n If the voip called-start normal command is configured, the voip called-tunnelenable command is unavailable.
