561By default, bridging over a PVC is disabled. If you configure both the map bridgevirtual-ethernet and map bridge-group commands, only the map bridgevirtual-ethernet takes effect.Example # Enable bridging over PVC 32/102. system-view[Sysname] interface atm 1/0[Sysname-Atm1/0] pvc 32/102[Sysname-atm-pvc-Atm1/0-32/102] map bridge-group broadcastreset bridge address-tableSyntax reset bridge address-table [ bridge-set bridge-set | dlsw | interface interface-typeinterface-number ]View User viewParameters bridge-set: Clears MAC address entries of the specified bridge set. bridge-set mustbe an integer in the range of 1 to 255.dlsw: Clears MAC address entries of the DLSw module.interface-type interface-number: Clears MAC address entry of the specifiedinterface.Description Use the reset bridge address-table command to remove one or more dynamicbridge table entries.Example # Clear all dynamic entries about bridge set 1 from the bridge table. reset bridge address-table bridge-set 1reset bridge trafficSyntax reset bridge traffic [ bridge-set bridge-set | dlsw | interface interface-typeinterface-number ]View User viewParameters bridge-set: Clears traffic statistics information about the specified bridge set.bridge-set must be an integer in the range of 1 to 255.dlsw: Clears the traffic statistics information about the DLSw module.interface-type interface-number: Clears the traffic statistics information about thespecified interface.Description Use the reset bridge traffic command to clear the statistic information aboutbridged traffic.
