1189no-export: Sets the no-export community attribute for matched BGP routes.Routes with this attribute are not advertised out the autonomous system orconfederation, but can be advertised to other sub ASs in the confederation.additive: Adds the specified community attributes to the original communityattribute of a matched BGP route.Description Use the apply community command to set the specified community attributefor BGP routes.Use the undo apply community command to remove the apply clause.No community attribute is set by default.Related commands: ip community-list, if-match community, route-policy.Examples # Create routing policy setcommunity with node 16 and matching mode aspermit. Set the no-export community attribute for BGP routes passingAS-path-ACL 8. system-view[Sysname] route-policy setcommunity permit node 16[Sysname-route-policy] if-match as-path 8[Sysname-route-policy] apply community no-exportapply costSyntax apply cost [ + | - ] valueundo apply costView Routing policy viewParameters +: Increases cost value.+: Decreases cost value.cost: Specifies a cost from 0 to 4294967295.Description Use the apply cost command to set a cost for routing information.Use the undo apply cost command to remove the clause configuration.No cost is set for routing information by default.Related commands: if-match interface, if-match acl, if-match ip-prefix, if-match ip next-hop,if-match cost, if-match tag, route-policy, apply ip-address next-hop, applylocal-preference, apply origin and apply tag.Examples # Create routing policy policy1 with node 10, matching mode as permit. If a routematches the outbound interface Serial 2/0, set the cost for the route to 120.
