1439source-group: Specifies to implement IPv6 multicast load splitting on a per-sourceand per-group basis.Description Use the multicast load-splitting command to enable load splitting of IPv6multicast traffic.Use the undo multicast load-splitting command to disable load splitting ofIPv6 multicast traffic.By default, load splitting of IPv6 multicast traffic is disabled.Example # Enable load splitting of IPv6 multicast traffic on a per-source basis. system-view[Sysname] multicast ipv6 load-splitting sourcemulticast ipv6 longest-matchSyntax multicast ipv6 longest-matchundo multicast ipv6 longest-matchView System viewParameter NoneDescription Use the multicast ipv6 longest-match command to configure route selectionbased on the longest match, namely based on the prefix length.Use the undo multicast ipv6 longest-match command to remove theconfiguration of route selection based on the longest match.By default, routes are selected in order of routing entries.Example # Configure route selection based on the longest match. system-view[Sysname] multicast ipv6 longest-matchmulticast ipv6 minimum-hoplimitSyntax multicast ipv6 minimum-hoplimit ttl-valueundo multicast ipv6 minimum-hoplimitView Interface viewParameter hoplimit-value: Minimum hop limit required for an IPv6 multicast packet to beforwarded on the interface, in the range of 1 to 255.
