132 CHAPTER 5: G.SHDSL INTERFACE CONFIGURATION COMMANDSdisplay dsl configurationSyntax display dsl configuration interface atm interface-numberView Any viewParameter interface-number: Specifies a iG.SHDSL interface to view the configurationinformation about.Description Use the display dsl configuration command to display actual GSHDSLconfigurations.Example # Display the actual configurations of G.SHDSL interface ATM 3/0. display dsl configuration interface atm 3/0GSHDSL line parameter and mode ConfigurationMode: CPEStandard: G.991.2Annex: BWire Type: 2Framing: 3Line Rate: Auto AdaptiveCurrent Margin: 2SNEXT margin: 0Psd Mode: Sym PSDLinkCheck: Disable--Actual Handshake Status --00: 0002 0000 0000 0000 0000 0000 0000 0000 0000 000010: 0000 0008 0000 0000 0000 0000 0000 0000 0008 000020: 0000 0000 0002 0002 0004 0010--Local Handshake Status --00: 0002 0001 0000 0000 0000 0000 0034 003f 003f 003f10: 003f 003f 0003 0034 003f 003f 003f 003f 003f 000320: 0000 0000 0003 0003 000f 0010--Remote Handshake Status --00: 0002 0000 0000 0000 0000 0000 0030 003f 003f 003f10: 003f 000f 0000 0030 003f 003f 003f 003f 000f 000020: 0000 0000 0003 0003 0004 0010Table 1 Description on the fields of the display dsl configuration commandField DescriptionMode Operating mode, customer premises equipment (CPE) orcentral office (CO)Standard The supported standardAnnex Available options are a and b.Wire Type Two-wire system or four-wire system.Framing Framing formatSNR Threshold Signal to noise ratio thresholdCurrent Margin Current marginSNEXT margin Worst-case margin
