Cadillac 2010 SRX Crossover Owner's Manual

Also see for 2010 SRX: Owner's manual Personalization guide Navigation system owner's manual

Contents

Keys, Doors and Windows 1-74. Press the ignition. When thetransmitter is learned the DICdisplay will show that it is readyto program the next transmitter.5. Remove the transmitter fromthe transmitter pocket andpress K on the transmitter.To program additionaltransmitters, repeat Steps 3through 5.When all additional transmittersare programmed, press and holdthe ignition for 5 seconds to exitprogramming mode.Programming without aRecognized Transmitter(Keyless Access Vehicles Only)If there are no currently recognizedtransmitters available, followthis procedure to program up toeight transmitters. This featureis not available in Canada. Thisprocedure will take approximately30 minutes to complete. Thevehicle must be off and all of thetransmitters you wish to programmust be with you.1. Insert the vehicle key of thetransmitter into the key lockcylinder located on the outsideof the driver door and turn thekey to the unlock positionfive times within ten seconds.The Driver Information Center(DIC) displays “Remote LearnPending, Please Wait”.2. Wait for ten minutes until theDIC displays “Press Engine StartButton To Learn” and then pressthe ignition.The DIC displays will againshow “Remote Learn Pending,Please Wait”.3. Repeat Step 2 two additionaltimes. After the third time allpreviously known transmitterswill no longer work with thevehicle. Remaining transmitterscan be relearned during the nextsteps.The DIC display should nowshow “Ready For Remote # 1”.