1-10 Keys, Doors and WindowsLaws in some local communitiesmay restrict the use of remotestarters. For example, some lawsmay require a person using remotestart to have the vehicle in view.Check local regulations for anyrequirements.There are other conditions whichcan affect the performance of thetransmitter, see Remote KeylessEntry (RKE) System on page 1‑3for additional information.Starting the Engine Using RemoteStartTo start the engine using the remotestart feature:1. Press Q on the RKE transmitter.2. Within three seconds, press andhold / until the turn signallamps flash. This confirms therequest to remote start thevehicle has been received. If thevehicle' s lamps are not visible,press and hold / for at leasttwo seconds.During the remote start thevehicle's doors will be lockedand the parking lamps willremain on as long as the engineis running.3. Press the brake pedal and selectthe ON/RUN/START ignitionmode to drive the vehicle.The engine will shut off after10 minutes unless a timeextension is done or the ignitionis put in ON/RUN/START.Extending Engine Run TimeFor a 10 minute extension, repeatSteps 1 and 2 while the engine isstill running. The remote start canonly be extended once.When the remote start is extended,the second 10 minute period willstart immediately.For example, if the vehicle hasbeen running for five minutes, and10 minutes are added, the enginewill run for a total of 15 minutes.A maximum of two remote starts orremote start attempts are allowedbetween ignition cycles.The vehicle's ignition must bechanged to ON/RUN/START andthen back to OFF before the remotestart procedure can be used again.Shutting the Engine Off After aRemote StartTo cancel a remote start:. Press / until the parking lampsturn off.. Turn on the hazard warningflashers.. Turn the ignition on and thenback off.Conditions in Which Remote StartWill Not WorkThe remote start will not operate if:. The ignition is in any mode otherthan OFF.. The transmitter is in the vehicle.. The hood is not closed.