314 VEHICLE CARE12. Unplug the power plug (8) fromthe accessory power outlet in thevehicle.13. Turn the sealant/air hose (6)counterclockwise to remove itfrom the tire valve stem.14. Replace the tire valve stem cap.15. Replace the sealant/air hose (6),and the power plug (8) back intheir original location.16. If the flat tire was able to inflateto the recommended inflationpressure, remove the maximumspeed label from the sealantcanister (5) and place it in ahighly visible location. Do notexceed the speed on this labeluntil the damaged tire is repairedor replaced.17. Return the equipment to itsoriginal storage location in thevehicle.18. Immediately drive the vehicle8 km (5 mi) to distribute thesealant in the tire.19. Stop at a safe location and checkthe tire pressure. Refer toSteps 1–11 under “Using the TireSealant and Compressor Kitwithout Sealant to Inflate a Tire(Not Punctured).”If the tire pressure has fallenmore than 68 kPa (10 psi) belowthe recommended inflationpressure, stop driving the vehicle.The tire is too severely damagedand the tire sealant cannot sealthe tire. See Roadside Service0 356.If the tire pressure has notdropped more than 68 kPa(10 psi) from the recommendedinflation pressure, inflate the tireto the recommended inflationpressure.20. Wipe off any sealant from thewheel, tire, and vehicle.21. Dispose of the used sealantcanister (5) and sealant/air hose(6) assembly at a local dealer orin accordance with local statecodes and practices.22. Replace with a new canisterassembly available from yourdealer.23. After temporarily sealing the tireusing the tire sealant andcompressor kit, take the vehicleto an authorized dealer within161 km (100 mi) of driving tohave the tire repaired orreplaced.
