KEYS, DOORS, AND WINDOWS 35The Driver Information Center(DIC) displays READY TO LEARNELECTRONIC KEY #2, 3, 4, ETC.4. Place the new transmitter intothe transmitter pocket. Open thecenter console storage area toaccess the transmitter pocket.5. Press ENGINE START/STOP.When the transmitter is learned,the DIC display will show that itis ready to program the nexttransmitter.6. Remove the transmitter from thetransmitter pocket and press Kor Q on the transmitter.To program additionaltransmitters, repeat Steps 4–6.When all additional transmittersare programmed, press and holdENGINE START/STOP forapproximately 12 seconds to exitprogramming mode.7. Return the vehicle key back intothe transmitter.Programming without RecognizedTransmittersIf two currently recognizedtransmitters are not available, followthis procedure to program up to eighttransmitters. This feature is notavailable in Canada. This procedurewill take approximately 30 minutes tocomplete. The vehicle must be off andall transmitters to be programmedmust be with you.1. Remove the vehicle key from thetransmitter.2. Remove the key lock cylindercap. See Door Locks 0 39. Insertthe vehicle key into the key lockcylinder on the driver doorhandle, then turn the keycounterclockwise to the unlockposition five times within10 seconds.The Driver Information Center(DIC) displays REMOTE LEARNPENDING, PLEASE WAIT.3. Wait for 10 minutes until theDIC displays PRESS ENGINESTART BUTTON TO LEARN andthen press ENGINESTART/STOP.The DIC display will again showREMOTE LEARN PENDING,PLEASE WAIT.4. Repeat Step 3 two additionaltimes. After the third time allpreviously known transmitterswill no longer work with thevehicle. Remaining transmitterscan be relearned during the nextsteps.The DIC display should nowshow READY FOR REMOTE # 1.
