DMA Channel Mux (DMACHMUX)MPC5606S Microcontroller Reference Manual, Rev. 7Freescale Semiconductor 4594. Select the source to be routed to the DMA channel. Write to the corresponding CHCONFIGregister, ensuring that the ENBL bit is set and the TRIG bit is cleared.Example 13-2. Configure source #5 transmit for use with DMA Channel 2, with no periodic triggeringcapability.1. Write 0x00 to CHCONFIG2 (base address + 0x02).2. Configure Channel 2 in the DMA, including enabling the channel.3. Write 0x85 to CHCONFIG2 (base address + 0x02).The following code example illustrates steps #1 and #3 above:In File registers.h:#define DMAMUX_BASE_ADDR 0xFC084000/* Example only ! *//* Following example assumes char is 8-bits */volatile unsigned char *CHCONFIG0 = (volatile unsigned char *) (DMAMUX_BASE_ADDR+0x0000);volatile unsigned char *CHCONFIG1 = (volatile unsigned char *) (DMAMUX_BASE_ADDR+0x0001);volatile unsigned char *CHCONFIG2 = (volatile unsigned char *) (DMAMUX_BASE_ADDR+0x0002);volatile unsigned char *CHCONFIG3 = (volatile unsigned char *) (DMAMUX_BASE_ADDR+0x0003);volatile unsigned char *CHCONFIG4 = (volatile unsigned char *) (DMAMUX_BASE_ADDR+0x0004);volatile unsigned char *CHCONFIG5 = (volatile unsigned char *) (DMAMUX_BASE_ADDR+0x0005);volatile unsigned char *CHCONFIG6 = (volatile unsigned char *) (DMAMUX_BASE_ADDR+0x0006);volatile unsigned char *CHCONFIG7 = (volatile unsigned char *) (DMAMUX_BASE_ADDR+0x0007);volatile unsigned char *CHCONFIG8 = (volatile unsigned char *) (DMAMUX_BASE_ADDR+0x0008);volatile unsigned char *CHCONFIG9 = (volatile unsigned char *) (DMAMUX_BASE_ADDR+0x0009);volatile unsigned char *CHCONFIG10= (volatile unsigned char *) (DMAMUX_BASE_ADDR+0x000A);volatile unsigned char *CHCONFIG11= (volatile unsigned char *) (DMAMUX_BASE_ADDR+0x000B);volatile unsigned char *CHCONFIG12= (volatile unsigned char *) (DMAMUX_BASE_ADDR+0x000C);volatile unsigned char *CHCONFIG13= (volatile unsigned char *) (DMAMUX_BASE_ADDR+0x000D);volatile unsigned char *CHCONFIG14= (volatile unsigned char *) (DMAMUX_BASE_ADDR+0x000E);volatile unsigned char *CHCONFIG15= (volatile unsigned char *) (DMAMUX_BASE_ADDR+0x000F);In File main.c:#include "registers.h"::*CHCONFIG2 = 0x00;*CHCONFIG2 = 0x85;13.5.2.3 Disabling a sourceA particular DMA source may be disabled by not writing the corresponding source value into any of theCHCONFIG registers. Additionally, some module-specific configuration may be necessary. Please referto the appropriate section for more details.13.5.2.4 Switching the source of a DMA channel1. Disable the DMA channel in the DMA and re-configure the channel for the new source.2. Clear the ENBL and TRIG bits of the DMA channel.3. Select the source to be routed to the DMA channel. Write to the corresponding CHCONFIGregister, ensuring that the ENBL and TRIG bits are set.