6 PKE-SWD-CP Connection for circuit-breaker PKE6.10 ProgrammingSmartWire-DT modules IP20 09/17 MN05006001Z EN www.eaton.com 1436.10 Programming6.10.1 PKE-SWD-CP cyclic dataThe PKE-SWD-CP has a maximum of eight input bytes and one output byte.6.10.1.1 InputsByte 0:Byte 1:→ The number of cyclical input bytes can be adjusted by means ofdifferent data profiles of the module (→ Section 6.10.2, „Dataprofiles“, page 150).7 6 5 4 3 2 1 0SUBST PRSNT – F – – Stat. –data bit designation Meaning0 Not used -1 STAT Contactor state PKE0: PKE switched off1: PKE Powered up2 Not used -3 Not used -4 F = Failure 0: No diagnostic alarm1: Module signals diagnostics5 Not used -6 PRSNT 0: Module not available1: Module available7 SUBST 0: Configured module present1: Universal module M22-SWD-NOP(C) present7 6 5 4 3 2 1 0– TRIPR TRIPR TRIPR Ir Ir Ir Irdata bit designation Meaning Notes0-3 I r Set value I r → Section 6.10.1.4, „Set value (Ir )“,page 1464-6 TRIPR =Trip reasonTrip reason → Section 6.10.1.5, „Differential tripindication (TRIPR)“, page 1477 Not used - -