7 Electronic motor starter EMS-…-SWD-ADP7.6 Exchange of modulesSmartWire-DT modules IP20 09/17 MN05006001Z EN www.eaton.com 163pressed). During the address assignment process, the diagnostic LED willflash. Once the address assignment process is complete, the diagnostic LEDwill show a solid green light.7.6 Exchange of modulesAfter replacing the modules and turning on the voltage, you will have topress the configuration button. When this is done, the new module will beassigned an address. DANGERThe entire SmartWire-DT system must be switched off beforereplacing the electronic motor starter.NOTICEThe order of the SmartWire-DT units must not be altered.￫ In order to make it possible to replace the EMS-…-SWD-ADPelectronic motor starter at a later point in time, make sure to setthe "compatible device allowed" parameter to a value of 1 withinthe application parameters for the SmartWire-DT coordinator.These parameters can be accessed in the PLC program's con-troller configuration. In the case of CANopen, these parameterscan be accessed using the SmartWire-DT gateway's ServiceData Objects.
